Circular Sectional Tanks

• Low cost hygienic storage
• Rugged and easily transportable
• Require minimal site preparation and foundations
• Quick and easy to install Can be installed using basic equipment
• Durable and long lasting
• Can be dismantled and re-erected at new site

• Abeco circular sectional steel tanks do not need concrete foundations
• Tanks can be installed on a flat, level and stable site covered by a bed of sand.
• If a concrete base is desired, a simple slab with standard mesh reinforcing will suffice. The base diameter should be 1m larger than the tank diameter.
• Slender tanks (tanks that are relatively high compared to diameter) may need to be fastened down for wind force.
• All components are lightweight, easy to transport and easy to man handle.
• Only simple tools are needed for installation.
• All parts and sealants needed to fully install the tanks are supplied.
• Pipe connection fittings are welded to shell side plates during manufacture before galvanizing.
• Tanks are supplied with access ladders, an access manhole and water level indicators.

• Tanks are of all bolted construction
• The tank shell panels are manufactured from carbon steel sheet.
• The shell panels are hot dip galvanized after manufacture.
• The side panel thickness is determined by the tank diameter and depth
• The minimum thickness recommended for sidewall panels is 2.5mm.
• Specially designed extruded rubber strips seal the sidewall panel seams.
• The tank roofs are made from galvanized steel roof sheeting.
• The tank roofs are cambered for water and dust run off.
• The floor of the tank is made from a durable vinyl sheet.
• A bed of sand or other suitable backing material protects the floor.
• Bolts and nuts are hot dip galvanized high tensile grade.
• All sealants are non-tainting, non toxic suitable for drinking water.